Garmin 696 TRAFFIC ONLY "TRF" Display with ADS B IN Traffic supplied from NAVWORX UAT
this picture was taken in flight of the Garmin 696 "TRF" Traffic Only display.
One aircraft is off to our right side, and the other traffic aircraft is behind us.
The Range rings are adjustable, shown in this picture with the closest range ring set at 2NM.
Velocity vector on TRAFFIC shows direction of flight
+XX indicated means the TRAFFIC is +XX hundred feet ABOVE our aircraft.
-YY indicated means the TRAFFIC is -YY hundred feet BELOW our aircraft.
In this example picture, the TRAFFIC data was supplied via ADS-B IN transmissions from FAA Ground Radio towers, which were received by a NAVWORX ADS-B OUT/IN Universal Access Transceiver (UAT). The NAVWORX received ADS-B IN traffic data was sent to the Garmin 696 by an electrical wire connected to the Garmin 696's serial data input.
The traffic indicators will look the same if (as another example), the traffic data is supplied to the Garmin 696 using
"TIS-B" data supplied by a Garmin GTX-330 Transponder (for example). Note that TIS-B traffic may not be as complete as ADS-B IN Traffic data.
ADS-B IN data is most complete for your aircraft if your aircraft is "Participating" in the Next Gen FAA Air Traffic Control system,
by transmitting Valid ADS-B "OUT" data from your aircraft.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.